Subaru IMPREZA GD 2007 Series Manual page 2394

asieps_tobira_IM_US.book 23 ページ ２０１２年１月１７日 火曜日 午後３時４８分
B: INSTALLATION
1) Inspect the union screw with filter. <Ref. to
LU(H4DOTC)-24, INSPECTING UNION SCREW
WITH FILTER, INSPECTION, Oil Pipe.>
2) Install the oil pipe.
NOTE:
• Make sure not to mix up the union screws with fil-
ter and without filter as their installation positions
are different.
• Use a new gasket.
Tightening torque:
T1: 8 N·m (0.8 kgf-m, 5.9 ft-lb)
T2: 29 N·m (3.0 kgf-m, 21.4 ft-lb)
(B)
(C)
(B)
(D)
(C)
(A)
(D)
(A) Union screw with filter (with protrusion)
(B) Union screw without filter (without protrusion)
(C) Oil pipe
(D) Gasket
3) Install the belt cover No. 2 LH.
Tightening torque:
5 N·m (0.5 kgf-m, 3.7 ft-lb)
Oil Pipe
(A)
(D)
(D)
LU-02546
CO-00024
LU(H4DOTC)-23
4) Install the cam sprocket
ME(H4DOTC)-56, INSTALLATION, Cam Sprock-
et.>
5) Install the timing belt. <Ref. to ME(H4DOTC)-51,
TIMING BELT, INSTALLATION, Timing Belt.>
6) Install the timing belt
ME(H4DOTC)-47, INSTALLATION, Timing Belt
Cover.>
7) Install the crank pulley. <Ref. to ME(H4DOTC)-
46, INSTALLATION, Crank Pulley.>
8) Install the V-belts. <Ref. to ME(H4DOTC)-44,
INSTALLATION, V-belt.>
9) Install the radiator main fan and the radiator sub
fan. <Ref. to CO(H4DOTC)-30, INSTALLATION,
Radiator Main Fan and Fan Motor.> <Ref. to
CO(H4DOTC)-32, INSTALLATION, Radiator Sub
Fan and Fan Motor.>
10) Install the intake
FU(H4DOTC)-20, INSTALLATION, Intake Mani-
fold.>
11) Connect the ground cable to battery.
LUBRICATION
LH. <Ref. to
cover. <Ref. to
manifold. <Ref. to
IN-00203