Ip Ospf Resync-Timeout - Allied Telesis IE340 Series Command Reference Manual

OSPF C
OMMANDS
-
IP OSPF RESYNC TIMEOUT

ip ospf resync-timeout

Overview Use this command to set the interval after which adjacency is reset if out-of-band
resynchronization has not occurred. The interval period starts from the time a
restart signal is received from a neighbor.
Use the no variant of this command to return to the default.
Syntax ip ospf [<ip-address>] resync-timeout <1-65535>
no ip ospf [<ip-address>] resync-timeout
Mode Interface Configuration for a VLAN interface.
Example To set the OSPF resynchronization timeout value to 65 seconds on the VLAN
interface vlan2, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
C613-50631-01 Rev A
Parameter Description
<ip-address>
The IP address of the interface.
<1-65535>
The resynchronization timeout value of the interface in seconds.
configure terminal
interface vlan2
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
ip ospf resync-timeout 65
1152