GE Senographe DS Manual page 1449

GE Healthcare
Revision 1
9. You are returned to the command prompt. Launch the Desktop Manager Configuration Tool again to
ensure that the Monitor settings are correct, by entering:
kdmconfig
The Desktop Manager Configuration Tool appears. Within the Desktop Manager Configuration Tool
you use the cursor keys to move up and down between the different options, and the space bar to
select an option. The currently selected option contains an x within the brackets.
10. At the first kdmconfig page, leave the Xsun server option selected.
Press the F2 key to continue.
11. At the kdmconfig - View and Edit Window System Configuration page that appears, use the cursor
keys to move to the Change Video Device/Monitor option, and press the space bar to select that
option. Press the F2 key to continue.
12. At the kdmconfig - Video Device Selection page that appears, use the cursor keys to move to the
XF86-NV Nvidia Corporation Quadro FX560 option, and press the space bar to select that option.
Press the F2 key to continue.
13. At the kdmconfig - Monitor Type Selection page that appears, use the cursor keys to move to the
MultiFrequency 64KHz (up to 1600x1200 interlacead) option, and press the space bar to select
that option. Press the F2 key to continue.
14. At the kdmconfig - Screen Size Selection page that appears, use the cursor keys to move to the
appropriate screen size option (18-inch (46cm) if the system uses an 18" monitor, or 19-inch (48cm)
if the system uses a 19" monitor), and press the space bar to select that option. Press the F2 key to
continue.
15. At the kdmconfig - Resolution/Colors Selection page that appears, use the cursor keys to move to the
1280x1024 256 colors @ 60Hz option, and press the space bar to select that option. Press the F2
key to continue.
16. At the kdmconfig - View and Edit Window System Configuration page that appears, leave the No
changes needed - Test/Save and Exit option selected. Press the F2 key to continue.
17. At the kdmconfig - Window System Configuration Test page that appears, press the F2 key to run the
screen test.
18. From the test screen that appears, click on:
• Yes, if screen is displayed correctly (buttons and text are readable).
• No, if screen is not displayed correctly and redo steps
Once the monitor test is successful, and you click Yes you are automatically returned to the com-
mand line.
19. At command prompt, ensure that the Control Station is in safe state for powering down, by entering:
shutdown -y -i 0
20. Power down the entire system, and proceed to
WARNING
Before proceeding to
Senographe system hospital supply circuit breaker. Lock it in the off position or mark it
clearly with a warning sign to prevent others from applying power.
JC-DR-A-315.fm
Service Information and Procedures Class A 2385072-16-8EN
section
section 8-2, shut down correctly the equipment and switch off the
Page no. 1449
Job Card D/R A315 - International Keyboard
11 to 17.
8-2.
Senographe DS
Chapter 9