GE Senographe DS Manual page 1594

GE Healthcare
Revision 1
Job Card D/R A409 - Relay Board 200-PL4
rotary switch in the Generator cabinet (position I).
7. Switch on the Senographe system electrical power (i.e. Generator, Gantry, and Control Station).
8. Wait until the Gantry boot is complete, and check that no error has been reported.
9. Reinstall the Generator covers (see
page 513).
7 COMPLETION
None.
Chapter 9
Service Information and Procedures Class A 2385072-16-8EN
Job Card PHY A042 - Remove/Reinstall Generator Covers on
Page no. 1594
Senographe DS
JC-DR-A-409.fm