Job Card D/R A321 - Idc Computer - GE Senographe DS Manual

GE Healthcare
Revision 1

Job Card D/R A321 - IDC Computer

1 SUPPLIES
• IDC Computer - Dione 4 or Dione 5, depending on your system level as follows:
- Go to the Service Desktop home page (see
- Consult Table 1 on page 63 in the section
Matrix on page
played on the Service Desktop home page, and by consulting Table 1 on page 63. The system
level will be defined by one of the System Level (Model Number) columns in Table 1 on page 63.
- If your system is at pre-Penduick level, order the Dione 4 (2375961)
- If your system is at Penduick or above level, order the Dione 5 (5324091)
• Floppy disk or CD-ROM with parameters for the currently installed image receptor
2 TOOLS
Standard Tool Kit
3 REQUIRED EFFORT
Personnel: 1 Field Engineer
Time: 90 minutes
4 SAFETY PRECAUTIONS
WARNING
Before beginning work, shut down the equipment correctly and switch OFF the
Senographe system hospital supply circuit breaker. Lock it in the OFF position and mark it
clearly with a warning sign to prevent others from applying power.
5 PREREQUISITES
• Remove Control Station omega cover. See
Covers on page 503.
• Backup the system configuration to a floppy diskette or a CD-R. See
Restore Procedure on page
all detector calibration procedures after the replacement.
JC-DR-A-321_DS.fm
63. Determine the system level from the ADS/IDC/Generator CPU versions dis-
771. If a current backup is not available, it will be necessary to carry out
Service Information and Procedures Class A 2385072-16-8EN
Launching the Service Desktop on page
Component FW/SW to ADS Version compatibility
Job Card PHY A040 - Remove/Reinstall Control Station
Page no. 1503
Senographe DS
Job Card D/R A321 - IDC Computer
Chapter 9
Job Card ELE A052 - Back-up/
120).
Chapter 9