Subaru IMPREZA GD 2007 Series Manual page 3538

asieps_tobira_IM_US.book 15 ページ ２０１２年１月１７日 火曜日 午後３時４８分
6. Side Airbag Module
A: REMOVAL
CAUTION:
Refer to "CAUTION" of "General Description"
before handling the airbag module. <Ref. to AB-
3, CAUTION, General Description.>
NOTE:
Remove the passenger's side by referring to driv-
er's side.
1) Turn the ignition switch to OFF.
2) Disconnect the ground cable from battery and
wait for at least 20 seconds before starting work.
3) Remove the front seats. <Ref. to SE-7, REMOV-
AL, Front Seat.>
4) Remove the clip from reverse side of seat cush-
ion assembly and slide rail IN (A), and then remove
the side airbag harness.
5) Remove the backrest cover. <Ref. to SE-8, DIS-
ASSEMBLY, Front Seat.>
6) Remove the side airbag harness from backrest
frame assembly.
Side Airbag Module
7) Remove the side airbag module (A) from back-
rest frame assembly.
B: INSTALLATION
CAUTION:
• Refer to "CAUTION" of "General Description"
before handling the airbag module. <Ref. to AB-
3, CAUTION, General Description.>
• Be sure to perform the system calibration for
occupant detection system after passenger's
seat installation. <Ref. to OD(diag)-18, SYSTEM
CALIBRATION
Subaru Select Monitor.>
1) Make sure that there is no foreign matter on side
airbag module.
2) Install the side airbag module (A) to backrest
frame assembly.
(A)
Tightening torque:
AB-00474
7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
AB-01397
AB-15
AIRBAG SYSTEM
(A)
(REZEROING),
(A)
AB-00916
OPERATION,
AB-00477