Subaru IMPREZA GD 2007 Series Manual page 3539

asieps_tobira_IM_US.book 16 ページ ２０１２年１月１７日 火曜日 午後３時４８分
AIRBAG SYSTEM
3) Install the side airbag harness to backrest frame
assembly.
NOTE:
Secure the harness to its original position of seat.
4) Install the backrest cover. <Ref. to SE-12, AS-
SEMBLY, Front Seat.>
5) Install side airbag harness to the slide rail IN (A),
and fix the connector to the bracket on the reverse
side of seat cushion assembly.
6) Recline the seat or slide it backward and for-
ward, and check there is no contact between the
seat backrest assembly, cushion cover assembly
and side airbag harness.
Side Airbag Module
C: INSPECTION
CAUTION:
Refer to "CAUTION" of "General Description"
before handling the airbag module. <Ref. to AB-
3, CAUTION, General Description.>
Check for the following, and replace the damaged
parts with new parts. <Ref. to AB-11, SIDE AIR-
BAG MODULE, INSPECTION, Inspection Loca-
tions After a Collision.>
1) With side collision (when side airbag is de-
ployed)
• Side airbag module assembly
• Backrest pad assembly
• Backrest frame assembly
• Backrest cover assembly
2) When damage is found by visual check
• Headrest assembly
• Bushing
• Slide rail OUT
• Slide rail IN
• Seat hinge cover
• Seat lifter lever
• Reclining lever
• Side airbag harness and connector on body side
3) With side collision (when side airbag is not de-
AB-01397
ployed)
Check the seat and airbag module visually, and
then replace them with new parts if damaged or
cracked.
Specially inspect the damage of airbag module
body, mounting bracket and harness connector.
4) Without side collision (dirt and damage of cover)
Replace the corresponding part with a new part.
(A)
AB-00474
AB-16