Subaru IMPREZA GD 2007 Series Manual page 3542

asieps_tobira_IM_US.book 19 ページ ２０１２年１月１７日 火曜日 午後３時４８分
9. Roll Connector
A: REMOVAL
1) Turn the ignition switch to OFF.
2) Disconnect the ground cable from battery and
wait for at least 20 seconds before starting work.
3) Remove the driver's airbag module. <Ref. to AB-
13, Driver's Airbag Module.>
4) Remove the steering wheel. <Ref. to PS-18, RE-
MOVAL, Steering Wheel.>
5) Remove the steering column cover.
6) Remove the screws, and then remove the roll
connector.
B: INSTALLATION
1) Install in the reverse order of removal.
2) Before installing the steering wheel, be sure to
adjust the direction of roll connector with steering.
<Ref. to AB-19, ADJUSTMENT, Roll Connector.>
C: INSPECTION
Check for the following, and replace the damaged
parts with new parts.
• Combination switch and roll connector are
cracked or deformed.
D: ADJUSTMENT
1) Check that front wheels are positioned in straight
ahead direction.
2) Turn the roll connector pin (A) clockwise until it
stops.
3) Turn the roll connector pins (A) approx. 3.25
turns until " " marks are aligned.
Roll Connector
AB-00917
(A)
AB-00594
AB-19
AIRBAG SYSTEM