Subaru IMPREZA GD 2007 Series Manual page 3540

asieps_tobira_IM_US.book 17 ページ ２０１２年１月１７日 火曜日 午後３時４８分
7. Airbag Control Module
A: REMOVAL
CAUTION:
• Do not disassemble the airbag control mod-
ule.
• If the airbag control module is deformed or if
the fault occurs by water, replace the airbag
control module with a new part.
• Do not drop the airbag control module.
• After removal, keep the airbag control mod-
ule on a dry, clean surface away from moisture,
heat and dust.
1) Turn the ignition switch to OFF.
2) Disconnect the ground cable from battery and
wait for at least 20 seconds before starting work.
3) Remove the console cover. <Ref. to EI-46, RE-
MOVAL, Console Box.>
4) Remove the center console panel. <Ref. to EI-
47, REMOVAL, Instrument Panel Assembly.>
5) Disconnect the connector from airbag control
module.
6) Remove the four bolts and remove airbag con-
trol module.
B: INSTALLATION
CAUTION:
Be sure to use the new bolts (exclusive use for
airbag control module) during installation.
Install in the reverse order of removal.
Tightening torque:
Refer to "COMPONENT" of "General Descrip-
tion". <Ref. to AB-2, SRS AIRBAG, COMPO-
NENT, General Description.>
C: INSPECTION
Check for the following, and replace the damaged
parts with new parts.
• Control module, connector, and mounting brack-
et are damaged.
• Airbag is deployed.
• Side airbag is deployed.
Airbag Control Module
AB-01384
AB-17
AIRBAG SYSTEM