Frame-Relay Intf-Type Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
frame-relay intf-type [dce | dte | nni]
Use the frame-relay intf-type command to define the Frame Relay signaling role needed for the endpoint.
Use the no form of this command to return to the default value.
Syntax Description
dce
dte
nni
Default Values
By default, frame-relay intf-type is set to dte.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 and Total Access 900 Series units.
Command History
Release 1.1
Usage Examples
The following example configures the Frame Relay endpoint for DCE signaling:
(config)#interface frame-relay 1
(config-fr 1)#frame-relay intf-type dce
61200990L1-35E
Specifies DCE or network-signaling role. Use this interface type when you need
the unit to emulate the frame switch.
Specifies DTE or user-signaling role. Use this interface type when connecting to a
Frame Relay switch (or piece of equipment emulating a frame switch).
Configures the interface to support both network and user signaling (DTE or DCE)
when necessary.
Command was introduced.
Copyright © 2005 ADTRAN
Frame Relay Interface Config Command Set
696