Crypto Map Manual Command Set - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
C M M
RYPTO AP
To activate the Crypto Map Manual mode, enter a valid version of the crypto map ipsec-manual
command at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#crypto map Map-Name 10 ipsec-manual
(config-crypto-map)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
description <text>
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
do on page 32
end on page 33
exit on page 34
All other commands for this command set are described in this section in alphabetical order.
antireplay on page 1053
ike-policy <policy number>
match address <listname>
set peer <address>
set session-key [inbound | outbound]
set transform-set <setname>
For VPN configuration example scripts, refer to the technical support note
Configuring VPN located on the ADTRAN OS Documentation CD provided with your
unit.
61200990L1-35E
C
ANUAL OMMAND
on page 31
on page 1054
on page 1055
on page 1057
on page 1058
on page 1062
Copyright © 2005 ADTRAN

Crypto Map Manual Command Set

S
ET
1052