Mac Address-Table Static Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
mac address-table static <mac address> bridge <bridge id> interface
<interface>
Use the mac address-table static command to insert a static MAC address entry into the bridge
forwarding table. Use the no form of this command to remove an entry from the table.
Syntax Description
<mac address>
<bridge>
interface
<interface>
Default Values
By default, there are no static entries configured.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 3000, 4000, and 5000 and Total Access 900 Series
units.
Command History
Release 10.1
Usage Examples
The following example adds a static MAC address to PPP 1 on bridge 4:
(config)#mac address-table static 00:A0:C8:00:00:01 bridge 4 interface ppp 1
61200990L1-35E
Specifies a valid 48-bit MAC address.
Specifies a valid bridge interface ID.
Specifies the interface. Type mac address-table static bridge interface ? for a
complete list of valid interfaces.
Specifies a valid slot/port interface ID.
Command was introduced.
Copyright © 2005 ADTRAN
Global Configuration Mode Command Set
432