Coding (T3 Interface Configuration Command) - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
coding [b3zs]
Use the coding command to configure the line coding for a T3 physical interface. This setting must match
the line coding supplied on the circuit by the service provider.
Syntax Description
b3zs
Default Value
By default, all T3 interfaces are configured with B3ZS line coding.
Applicable Platforms
This command applies to the NetVanta 5000 Series.
Command History
Release 6.1
Functional Notes
The line coding configured in the unit must match the line coding of the T3 circuit. A mismatch will result in
line errors (e.g., BPVs).
Usage Example
The following example configures the T1 interface for B3ZS line coding:
(config)#interface t3 1/1
(config-t3 1/1)#coding b3zs
61200990L1-35E
Configures the line coding for bipolar three zero substitution (B3ZS).
Command was introduced.
Copyright © 2005 ADTRAN
T3 Interface Configuration Command Set
622