Command Reference Guide
set peer <address>
Use the set peer command to set the IP address of the peer device.
Syntax Description
<address>
Default Values
There are no default settings for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 Series units.
Command History
Release 4.1
Functional Notes
If no peer IP address is configured, the manual crypto map is not valid and not complete. A peer IP
address is required for manual crypto maps. To change the peer IP address, the no set peer command
must be issued first; then the new peer IP address can be configured.
Usage Examples
The following example sets the peer IP address of 10.100.23.64:
(config-crypto-map)#set peer 10.100.23.64
61200990L1-35E
Specifies the IP address of the peer device.
Command was introduced.
Copyright © 2005 ADTRAN
Crypto Map Manual Command Set
1057