Кadius-Server Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
radius-server
Use the radius-server command to configure several global RADIUS parameters. Most of these global
defaults can be overridden on a per-server basis.
Variations of this command include the following:
radius-server challenge-noecho
radius-server deadtime <minutes>
radius-server enable-username <name>
radius-server key <key>
radius-server retry <attempts>
radius-server timeout <seconds>
Syntax Description
challenge-noecho
deadtime <minutes>
enable-username <name>
key <key>
retry <attempts>
timeout <seconds>
Default Values
challenge-noecho
deadtime
key
retry
timeout
enable-username
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
61200990L1-35E
Turns off echoing of user challenge-entry. When echo is turned on, users
see the text of the challenge as they type responses. Enabling this option
hides the text as it is being entered.
Specifies how long a RADIUS server is considered dead once a timeout
occurs. The server will not be tried again until after the deadtime expires.
Specifies a username to be used for enable authentication.
Specifies the shared key to use with a RADIUS server.
Specifies how many attempts to make on a RADIUS server before marking
it dead.
Specifies how long to wait for a RADIUS server to respond to a request.
By default, echo is turned on.
1 minute
No default
3 attempts
5 seconds
$enab15$
Copyright © 2005 ADTRAN
Global Configuration Mode Command Set
436