Show Spanning-Tree Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
show spanning-tree <bridgegroup#>
Use the show spanning-tree command to display the status of the spanning-tree protocol.
Syntax Description
<bridgegroup#>
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 5.1
Usage Examples
The following is an example output using the show spanning-tree command:
>enable
#show spanning-tree
Spanning Tree enabled protocol ieee
Root ID Priority 32768
Address 00:a0:c8:00:88:41
We are the root of the spanning tree
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
Bridge ID Priority 32768
Address 00:a0:c8:00:88:41
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
Aging Time 300
Interface
-------------------
eth 0/2
eth 0/3
eth 0/4
giga-eth 0/1
giga-eth 0/2
61200990L1-35E
Optional. Displays spanning-tree for a specific bridge group.
Command was introduced.
Role
-------------------
Desg
Desg
Desg
Desg
Desg
Copyright © 2005 ADTRAN
Sts Cost
------------------- -----------
FWD 19
FWD 19
FWD 19
FWD 4
FWD 4
Enable Mode Command Set
Prio.Nbr Type
------------- ---------------
128.2 P2p
128.3 P2p
128.4 P2p
128.25 P2p
128.26 P2p
261