Snmp-Server Enable Traps Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
snmp-server enable traps <trap type> [snmp]
Use the snmp-server enable traps command to enable all Simple Network Management Protocol
(SNMP) traps available on your system or specified using the <trap type> option. Use multiple
snmp-server enable traps to enable multiple trap types. Use the no form of this command to disable traps
(or the specified traps).
Syntax Description
<trap type>
snmp
Default Values
By default, there are no enabled traps.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 1.1
Usage Examples
The following example enables the SNMP traps:
(config)#snmp-server enable traps snmp
61200990L1-35E
Specifies the type of notification trap to enable. Leaving this option blank enables
ALL system traps.
Optional. Enables a subset of traps specified in RFC1157.
The following traps are supported:
coldStart
warmStart
linkUp
linkDown
authenticationFailure
Command was introduced.
Copyright © 2005 ADTRAN
Global Configuration Mode Command Set
450