Show Ip Mroute Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
show ip mroute [<group-address> | <interface>] [summary | all]
Use the show ip mroute command to display IP multicasting routing table information.
Syntax Description
<group-address>
<interface>
summary
all
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 7.1
Release 9.1
Release 11.1
Usage Examples
The following is sample output from the show ip mroute command:
>enable
#show ip mroute
IP Multicast Routing Table
Flags: S - Sparse, C - Connected, P - Pruned, J - Join SPT, T - SPT-bit Set,
F - Register, R - RP-bit Set
Timers: Uptime/Expires
(*, 225.1.0.1), 01:16:21/00:02:45, RP 192.168.0.254, Flags: SC
Incoming interface: tunnel 2, RPF nbr 172.16.2.10
Outgoing interface list:
eth 0/1, Forward, 01:16:21/00:02:45
61200990L1-35E
Optional. Displays IP address of a multicast group.
Optional. Displays the parameters for a specific interface (in the format type
slot/port). For example: eth 0/1.
Optional. Displays a single-line summary for each entry in the IP multicast routing
table.
Optional: Displays all multicast routes, including those not used to forward
multicast traffic.
Command was introduced.
Command was expanded to include HDLC and tunnel interfaces.
The All option was added.
Copyright © 2005 ADTRAN
Enable Mode Command Set
209