Ip Ospf Command (Ppp Interface Configuration Command) - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
ip ospf
Use the ip ospf command to customize OSPF settings (if needed).
Syntax Description
authentication-key
<password>
cost <value>
dead-interval <seconds>
hello-interval <seconds>
message-digest-key
<keyid> md5 <key>
priority <value>
retransmit-interval
<seconds>
transmit-delay <seconds>
Default Values
retransmit-interval
<seconds>
transmit-delay <seconds>
hello-interval <seconds>
dead-interval <seconds>
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 3.1
Usage Example
The following example sets the maximum number of seconds allowed between hello packets to 25,000:
(config)#interface ppp 1
(config-ppp 1)#ip ospf dead-interval 25000
61200990L1-35E
Assigns a simple-text authentication password to be used by other routers
using the OSPF simple password authentication.
Specifies the OSPF cost of sending a packet on the interface. This value
overrides any computed cost value. Range: 165,535.
Sets the maximum interval allowed between hello packets. If the maximum
is exceeded, neighboring devices will determine that the device is down.
Range: 0 32,767.
Specifies the interval between hello packets sent on the interface. Range: 0
32,767.
Configures OSPF Message Digest 5 (MD5) authentication (16-byte max)
keys.
Sets the OSPF priority. The value set in this field helps determine the
designated router for this network. Range: 0 255.
Specifies the time between link-state advertisements (LSAs). Range: 0
32,767.
Sets the estimated time required to send an LSA on the interface. Range: 0
32,767.
5 seconds
1 second
10 seconds: Ethernet, point-to-point, Frame Relay, and PPP
40 seconds
Command was introduced.
Copyright © 2005 ADTRAN
PPP Interface Configuration Command Set
930