Show Pppoe Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
show pppoe
Use the show pppoe command to display all point-to-point over Ethernet (PPPoE) settings and associated
parameters.
Syntax Description
No subcommands.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 6.1
Usage Examples
The following example enters the Enable mode and uses the show command to display PPPoE
information:
>enable
#show pppoe
ppp 1
Outgoing Interface: eth 0/1
Outgoing Interface MAC Address: 00:A0:C8:00:85:20
Access-Concentrator Name Requested: FIRST VALID
Access-Concentrator Name Received: 13021109813703-LRVLGAOS90W_IFITL
Access-Concentrator MAC Address: 00:10:67:00:1D:B8
Session Id: 64508
Service Name Requested: ANY
Service Name Available:
PPPoE Client State: Bound (3)
Redial retries: unlimited
Redial delay: 10 seconds
Backup enabled all day on the following days:
Sunday Monday Tuesday Wednesday Thursday Friday Saturday
Backup phone number list:
Number Call Type min/max DS0s Backup I/F
5551212 analog
61200990L1-35E
Command was introduced.
1/1 ppp 2
Copyright © 2005 ADTRAN
Enable Mode Command Set
242