Frame Relay Interface Config Command Set - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
F R
RAME ELAY
To activate the Frame Relay Interface Configuration mode, enter the interface frame-relay command at
the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface frame-relay 1
(config-fr 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <"text"> on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text>
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
bandwidth <value>
encapsulation frame-relay ietf
fair-queue <threshold>
frame-relay commands
hold-queue <queue size> out
max-reserved-bandwidth <percent>
qos-policy out <mapname>
snmp trap on page 712
snmp trap link-status
61200990L1-35E
I C
NTERFACE ONFIG
on page 31
on page 693
on page 694
on page 695
begin on page 696
on page 708
on page 709
on page 710
on page 713
Copyright © 2005 ADTRAN

Frame Relay Interface Config Command Set

C S
OMMAND ET
692