Logging Email Receiver-Ip Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
logging email receiver-ip <ip address>
Use the logging email receiver-ip command to specify the IP address of the email server to use when
sending notification that an event matched the criteria configured using the logging email priority-level
command. Refer to logging email priority-level [error | fatal | info | notice | warning]
related information. Use the no form of this command to remove a configured address.
Syntax Description
<ip address>
Default Values
By default, there are no configured email server addresses.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 1.1
Usage Examples
The following example specifies an email server (with address 172.5.67.99) to use when sending logged
messages:
(config)#logging email receiver-ip 172.5.67.99
61200990L1-35E
Specifies the IP address (in dotted decimal notation) of the mail server to use
when sending logged messages.
Command was introduced.
Copyright © 2005 ADTRAN
Global Configuration Mode Command Set
on page 421 for
422