Username Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
username <username> password <password>
Use this command to configure the username and password to use for all protocols requiring a
username-based authentication system including FTP server authentication, line (login local-user list), and
HTTP access.
Syntax Description
<username>
<password>
Default Values
By default, there is no established username and password.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 1.1
Functional Notes
All users defined using the username/password command are valid for access to the unit using the login
local-userlist command.
Usage Examples
The following example creates a username of ADTRAN with password ADTRAN:
(config)#username ADTRAN password ADTRAN
CODEC List Command Set
mand Set on page 1734Voice Trunk Analog LS/GS Command Set
Command Set on page 1640Voice Trunk ISDN Command Set
Set on page 1717VLAN Configuration Command Set
61200990L1-35E
Specifies a username using an alphanumerical string up to 30 characters in length
(the username is case-sensitive).
Specifies a password using an alphanumerical string up to 30 characters in length
(the password is case-sensitive).
Command was introduced.
on page 1586Voice Trunk Group Command Set
Copyright © 2005 ADTRAN
Global Configuration Mode Command Set
on page
on page 1660Voice Trunk Analog DPT
on page 1689Voice Trunk T1 Wink Command
on page 655
1684Voice User Com-
469