Ip Address Dhcp Command (Ppp Interface Configuration Command) - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
ip address dhcp
Use the ip address dhcp command to use Dynamic Host Configuration Protocol (DHCP) to obtain an
address on the interface. Use the no form of this command to remove a configured IP address (using
DHCP) and disable DHCP operation on the interface.
Syntax Description
No subcommands.
Default Values
No default is necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 2.1
Release 8.1
Usage Examples
The following example enables DHCP operation on the PPP interface 1:
(config)#interface ppp 1
(config-ppp 1)#ip address dhcp
61200990L1-35E
Command was introduced.
Command expanded to include PPP interface.
Copyright © 2005 ADTRAN
PPP Interface Configuration Command Set
920