Ip Ospf Authentication Command (Loopback Interface Configuration) - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
ip ospf authentication [message-digest | null]
Use the ip ospf authentication command to authenticate an interface that is performing OSPF
authentication.
Syntax Description
message-digest
null
Default Values
By default, this is set to null (meaning no authentication is used).
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 3.1
Usage Examples
The following example specifies that no authentication will be used on the loopback interface:
(config)#interface loopback 1
(config-loop 1)#ip ospf authentication null
61200990L1-35E
Optional. Specifies the message-digest authentication type.
Optional. Specifies for no authentication to be used.
Command was introduced.
Copyright © 2005 ADTRAN
Loopback Interface Configuration Command Set
866