Ike Policy Command Set - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
IKE P C
OLICY
To activate the IKE Policy mode, enter the crypto ike policy command at the Global Configuration mode
prompt. For example:
>enable
#configure terminal
(config)#crypto ike policy 1
(config-ike)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
do on page 32
end on page 33
exit on page 34
All other commands for this command set are described in this section in alphabetical order.
attribute <policynumber>
client authentication host
client authentication host xauth-type [generic | otp | radius]
client authentication server list <listname>
client configuration pool <poolname>
initiate [main | aggressive]
local-id [address | asn1-dn | fqdn | user-fqdn] <ipaddress or name>
nat-traversal <version> [allow | disable | force]
peer [<ip address> | any]
respond [main | aggressive | anymode]
For VPN configuration example scripts, refer to the technical support note
Configuring VPN located on the ADTRAN OS Documentation CD provided with your
unit.
61200990L1-35E
S
OMMAND ET
on page 1074
on page 1075
on page 1078
on page 1079
on page 1083
on page 1085
Copyright © 2005 ADTRAN
on page 1076
on page 1077
on page 1082

IKE Policy Command Set

on page 1080
1073