ADTRAN 5000 Series Command Reference Manual page 393

Command Reference Guide Global Configuration Mode Command Set
nat source list <access list names> interface <interface> overload policy <access policy name>
All packets passed by the access list(s) and destined for the interface using the access policy listed will be
modified to replace the source IP address with the primary IP address of the listed interface. The overload
keyword allows multiple source IP addresses to be replaced with the single IP address of the specified
interface. This hides private IP addresses from outside the local network.
nat destination list <access list names> address <IP address>
All packets passed by the access list(s) entered will be modified to replace the destination IP address with
the entered IP address. The overload keyword is not an option when performing NAT on the destination IP
address; each private address must have a unique public address. This hides private IP addresses from
outside the local network.
Step 4:
Apply the created access policy to an interface. To assign an access policy to an interface, enter the
interface configuration mode for the desired interface and enter access policy <policy name>. The
following example assigns access policy MatchAll to the Ethernet 0/1 interface:
(config)#interface ethernet 0/1
(config-eth 0/1)#access-policy MatchAll
61200990L1-35E Copyright © 2005 ADTRAN 393