Ip Crypto Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
ip crypto
Use the ip crypto command to enable AOS VPN functionality and allow crypto maps to be added to
interfaces. Use the no form of this command to disable the VPN functionality.
Disabling the AOS security features (using the no ip crypto command) does not affect VPN
configuration settings (with the exception of the removal of all crypto maps from the
interfaces). All other configuration parameters will remain intact, and VPN functionality
will be disabled.
For VPN configuration example scripts, refer to the VPN Configuration Guide located on
the ADTRAN OS Documentation CD provided with your unit.
Syntax Description
No subcommands.
Default Values
By default, all AOS VPN functionality is disabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 4.1
Functional Notes
VPN-related settings will not go into effect until you enable VPN functionality using the ip crypto
command. The AOS allows you to perform all VPN-related configuration prior to enabling ip crypto, with
the exception of assigning a crypto map to an interface. The no ip crypto command removes all crypto
maps from the interfaces. Enabling ip crypto enables the IKE server on UDP Port 500. The no form of this
command disables the IKE server on UDP Port 500.
Usage Examples
The following example enables VPN functionality:
(config)#ip crypto
61200990L1-35E
Command was introduced.
Copyright © 2005 ADTRAN
Global Configuration Mode Command Set
355