Client Configuration Pool Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
client configuration pool <poolname>
Use the client configuration pool command to configure the AOS to perform as mode-config server (edge
device) when an IKE policy is negotiated.
Variations of this command include the following:
client configuration pool <poolname>
client configuration pool <poolname> initiate
client configuration pool <poolname> initiate respond
client configuration pool <poolname> respond
client configuration pool <poolname> respond initiate
Syntax Description
<poolname>
Default Values
By default, if this command is not present in the IKE policy, the ADTRAN device allocates mode-config IP
addresses, DNS server addresses, and NetBIOS name server addresses, and mode-config is not
performed.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 4.1
Functional Notes
This command ties an existing client configuration pool to an IKE policy.
Usage Examples
The following example ties the ConfigPool1 configuration pool to this IKE policy:
(config-ike)#client configuration pool ConfigPool
61200990L1-35E
The pool from which to obtain parameters to assign to the client.
Command was introduced.
Copyright © 2005 ADTRAN
IKE Policy Command Set
1078