Signaling-Mode Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
signaling-mode [message-oriented | none | robbed-bit]
Use the signaling-mode command to configure the signaling type (robbed-bit for voice or clear channel
for data) for the DS0s mapped to the DSX-1 port.
Syntax Description
message-oriented
none
robbed-bit
Default Values
By default, the signaling mode is set to robbed-bit.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 and Total Access 900 Series units.
Command History
Release 1.1
Usage Examples
The following example configures the DSX-1 port for PRI compatibility:
(config)#interface t1 1/2
(config-t1 1/2)#signaling-mode none
61200990L1-35E
Specifies clear channel signaling on Channel 24 only. Use this signaling type with
QSIG installations.
Specifies clear channel signaling on all 24 DS0s. Use this signaling type with
data-only or PRI DSX-1 installations.
Specifies robbed bit signaling on all DS0s. Use this signaling type for voice-only
DSX-1 applications.
Command was introduced.
Copyright © 2005 ADTRAN
DSX-1 Interface Configuration Command Set
507