Peer Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
peer [<ip address> | any]
Use the peer command to enter the IP address of the peer device. Repeat this command for multiple peers.
Use the any keyword if you want to set up a policy that will initiate or respond to any peer.
Syntax Description
<ip address>
any
Default Values
There are no default settings for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 4.1
Functional Notes
An IKE policy is incomplete unless one of the peer commands is specified. Only one IKE policy can be
configured with peer any.
Usage Examples
The following example sets multiple peers on an IKE policy for an initiate-and-respond policy using
pre-shared secret, DES, MD5, and Diffie-Hellman Group 1:
(config)#crypto ike policy 100
(config-ike)#peer 63.97.45.57
(config-ike)#peer 63.105.15.129
(config-ike)#peer 192.168.1.3
(config-ike)#respond anymode
(config-ike)#initiate main
61200990L1-35E
Specifies a peer IP address.
Allows any peer to connect to this IKE policy.
Command was introduced.
Copyright © 2005 ADTRAN
IKE Policy Command Set
1083