Line (Telnet) Interface Config Command Set - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
L (T ) I
INE ELNET
To activate the Line (Telnet) Interface Configuration mode, enter the line telnet command specifying a
Telnet session(s) at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#line telnet 0 4
(config-telnet0-4)#
You can select a single line by entering the line telnet command followed by the line number (0-4). For
example:
>enable
#configure terminal
(config)#line telnet 2
(config-telnet2)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
access-class <listname> in
accounting commands [<level> l <name> l default]
authorization commands [<level> l <name> l default]
line-timeout <minutes>
login on page 496
login authentication <aaa login list>
login local-userlist
password [md5] <password>
61200990L1-35E
C
NTERFACE ONFIG
on page 492
on page 495
on page 497
on page 498
on page 499
Copyright © 2005 ADTRAN

Line (Telnet) Interface Config Command Set

C S
OMMAND ET
on page 493
on page 494
491