Vlan-Id Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
vlan-id <vlan id> [native]
Use the vlan-id command to set a VLAN ID for the Ethernet interface. Use the no form of this command
to remove an entry.
Syntax Description
<vlan id >
native
Default Values
By default, no VLAN ID is set.
Applicable Platforms
This command applies to the NetVanta 3000, 4000, and 5000 and Total Access 900 Series units.
Command History
Release 6.1
Usage Examples
The following example configures a native VLAN of 5 for the Ethernet interface 0/1:
(config)#interface eth 0/1
(config-eth 0/1)#vlan-id 5 native
61200990L1-35E
Specifies a valid VLAN interface ID number (1 to 4095).
Optional. Specifies that data for that VLAN ID goes out untagged. If native is not
specified, data for that VLAN ID goes out tagged.
Command was introduced.
Copyright © 2005 ADTRAN
Ethernet Interface Configuration Command Set
591