Spanning-Tree Mode Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
spanning-tree mode [rstp | stp]
Use the spanning-tree mode command to choose a spanning-tree mode of operation.
Syntax Description
rstp
stp
Default Values
By default, spanning-tree mode is set to rstp.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 5.1
Usage Examples
The following example sets the spanning-tree mode to rapid spanning-tree protocol:
(config)#spanning-tree mode rstp
61200990L1-35E
Enables rapid spanning-tree protocol.
Enables spanning-tree protocol.
Command was introduced.
Copyright © 2005 ADTRAN
Global Configuration Mode Command Set
463