Radius Group Command Set - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
R G
ADIUS ROUP
To activate the Radius Group mode, enter the aaa group server command at the Global Configuration
mode prompt. For example:
>enable
#configure terminal
(config)#aaa group server radius myServer
(config-sg-radius)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text>
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
server [acct-port <port number>| auth-port <port number>]
61200990L1-35E
C S
OMMAND
on page 31
Copyright © 2005 ADTRAN
ET
on page 1170

Radius Group Command Set

1169