Table of Contents
Advertisement
Command Reference Guide
E1 I
NTERFACE
To activate the E1 Interface Configuration mode, enter the interface e1 command (and specify the E1
port) at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface e1 1/1
(config-e1 1/1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <"text">
on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text>
do
on page 32
end
on page 33
exit
on page 34
shutdown
on page 35
All other commands for this command set are described in this section in alphabetical order.
clock source [internal | line | through]
coding [ami | hdb3]
framing [crc4]
on page 513
loop-alarm-detect
on page 514
loopback network [line | payload]
loopback remote v54
remote-alarm [rai | ais]
remote-loopback
on page 518
sa4tx-bit [0 | 1]
on page 519
show test-pattern
on page 520
snmp trap line-status
snmp trap link-status
snmp trap threshold-reached
tdm-group <group number> timeslots <1-31> speed [56 | 64]
test-pattern [clear | insert | ones| p215 | p220 | p511 | qrss | zeros]
ts16
on page 526
61200990L1-35E
C
ONFIGURATION
on page 31
on page 511
on page 512
on page 515
on page 516
on page 517
on page 521
on page 522
on page 523
Copyright © 2005 ADTRAN
E1 Interface Configuration Command Set
C
S
OMMAND
ET
on page 524
on page 525
510
- Quick Links:
- Basic Mode Command Set
- Common Commands
Hide quick links:
Advertisement
Table of Contents
