Line-Length - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
line-length [short | long]
Use the line-length command to configure the line length for a T3 physical interface.
Syntax Description
short
long
Default Value
By default, all T3 interfaces are configured for a short line length.
Applicable Platforms
This command applies to the NetVanta 5000 Series.
Command History
Release 6.1
Usage Examples
The following example configures the T3 interface for long line length:
(config)#interface t3 1/1
(config-t3 1/1)#line-length long
61200990L1-35E
Configures the line length for a distance of 0 to 225 feet of cable.
Configures the line length for a distance of 225 to 450 feet of cable.
Command was introduced.
Copyright © 2005 ADTRAN
T3 Interface Configuration Command Set
624