Ip Pim-Sparse Override-Interval Command (Loopback Interface Configuration) - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
ip pim-sparse override-interval <time>
Use the ip pim-sparse override-interval command to specify the protocol-independent multicast (PIM)
sparse join/prune override interval. This delay interval is the period after a join/prune that another router on
the LAN may override a join/prune. Use the no form of this command to return to the default value.
Syntax Description
<time>
Default Values
By default, the override-interval is set to 2500 milliseconds.
Applicable Platforms
This command applies to the NetVanta 2000 and 5000 and Total Access 900 Series units.
Command History
Release 11.1
Usage Examples
The following example sets the override-interval to 3000 milliseconds:
(config)#interface loopback 1
(config-loop 1)#ip pim-sparse override-interval 3000
61200990L1-35E
Specifies the delay time in milliseconds. Valid range is 0 to 65,535 milliseconds.
Command was introduced.
Copyright © 2005 ADTRAN
Loopback Interface Configuration Command Set
872