Ip Firewall Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
ip firewall
Use the ip firewall command to enable AOS security features including access control policies and lists,
Network Address Translation (NAT), and the stateful inspection firewall. Use the no form of this
command to disable the security functionality.
Disabling the AOS security features (using the no ip firewall command) does not affect
security configuration. All configuration parameters will remain intact, but no security
data processing will be attempted.
For information regarding the use of OSPF with ip firewall enabled, refer to the
Functional Note for router ospf
Regarding the use of IKE negotiation for VPN with ip firewall enabled, there can be up to
six channel groups with 2 to 8 interfaces per group. Dynamic protocols are not yet
supported (only static). A physical interface can be a member of only one channel group.
Syntax Description
No subcommands.
Default Values
By default, all AOS security features are disabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 2.1
61200990L1-35E
Command was introduced.
Copyright © 2005 ADTRAN
Global Configuration Mode Command Set
on page 441.
365