Ntp-Server Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
ntp-server <ip address>
Use the ntp-server command to specify the name of the Network Time Protocol (NTP) server published to
the client.
Syntax Description
<ip address>
Default Values
By default, no NTP server is defined.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 9.1
Usage Examples
The following example specifies the IP address of the NTP server:
(config)#ip dhcp pool MyPool
(config-dhcp)#ntp-server 192.168.1.1
61200990L1-35E
Specifies the IP address of the NTP server.
Command was introduced.
Copyright © 2005 ADTRAN
DHCP Pool Command Set
1159