Hssi Interface Configuration Command Set - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
HSSI I
NTERFACE
To activate the HSSI Interface Configuration mode, enter the interface hssi command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface hssi 1/1
(config-hssi 1/1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <"text"> on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text>
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
external-loopback-request
loopback [dce | dte | line | remote | none]
snmp trap link-status
61200990L1-35E
C
ONFIGURATION
on page 31
on page 600
on page 601
on page 602
Copyright © 2005 ADTRAN

HSSI Interface Configuration Command Set

C S
OMMAND ET
599