Spanning-Tree Edgeport Default Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide Global Configuration Mode Command Set
spanning-tree edgeport default
Use the spanning-tree edgeport default command to configure all ports to be edgeports by default. Use
the no form of this command to disable the setting.
Syntax Description
No subcommands.
Default Values
Disabled by default.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 3000, and 4000 and Total Access 900 Series
units.
Command History
Release 5.1 Command was introduced.
Usage Examples
The following example configures all interfaces running spanning tree to be edgeports by default:
(config)#spanning-tree edgeport default
An individual interface can be configured to not be considered an edgeport. For example:
(config)#interface ethernet 0/1
(config-eth 0/1)#spanning-tree edgeport disable
or
(config)#interface ethernet 0/1
(config-eth 0/1)#no spanning-tree edgeport
61200990L1-35E Copyright © 2005 ADTRAN 459