Set Ip Next-Hop Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide Route Map Command Set
set ip next-hop <ip address>
Use the set ip next-hop command to specify the interface for the next hop. Multiple IP addresses can be
specified. The packet is forwarded along the first usable IP address. Use the no form of this command to
cancel the next hop.
Syntax Description
<ip address> Specifies the IP address for the next hop.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 2000 and 5000 Series, and Total Access 900 Series units.
Command History
Release 11.1 Command was introduced.
Usage Examples
The following example sets the next hop IP address as 10.10.11.254 in the header of the route map named
MyMap:
(config)#route-map MyMap permit 100
(config-route-map)#set ip next-hop 10.10.11.254
61200990L1-35E Copyright © 2005 ADTRAN 1189