Ip Host Command; Ip Host <Name> <Address - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
ip host <name> <address1>
Use the ip host command to define an IP host name. This allows you to statically map host names and
addresses in the host cache. Use the no form of this command to remove defined maps.
Syntax Description
<name>
<address1>
Default Values
By default, the host table is empty.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 3.1
Functional Notes
The name may be any combination of numbers and letters as long as it is not a valid IP address or does
not exceed 256 characters.
Usage Examples
The following example defines two static mappings:
(config)#ip host mac 10.2.0.2
(config)#ip host dal 172.38.7.12
61200990L1-35E
Defines the name of the host.
Specifies IP address associated with this IP host.
Command was introduced.
Copyright © 2005 ADTRAN
Global Configuration Mode Command Set
383