Ip Rip Send Version - To Use The Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
ip rip send version [1 | 2]
Use the ip rip send version command to configure the RIP version the unit sends in all RIP packets
transmitted on the interface. Use the no form of this command to restore the default value.
Syntax Description
1
2
Default Values
By default, all interfaces transmit RIP version 1 (the default value for the version command).
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 3000, 4000, and 5000 and Total Access 900 Series
units.
Command History
Release 9.1
Functional Notes
Use the ip rip send version command to specify a RIP version that overrides the version (in the Router
RIP) configuration. See
The AOS only transmits one version (either 1 or 2) on a given interface.
Usage Examples
The following example configures the HDLC interface to transmit only RIP version 2 packets:
(config)#interface hdlc 1
(config-hdlc 1)#ip rip send version 2
61200990L1-35E
Only transmits RIP version 1 packets on the interface.
Only transmits RIP version 2 packets on the interface.
Command was introduced.
version [1 | 2] on page 1144
Copyright © 2005 ADTRAN
for more information.
HDLC Command Set
834