Show Lldp Neighbors Interface Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
show lldp neighbors [interface <interface> l <interface type> | detail |
realtime]
Use the show lldp neighbors interface command to display information about neighbors of this device
learned about via local loop demarkation point (LLDP).
Syntax Description
<interface>
<interface type>
detail
realtime
Default Values
No default values necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 8.1
Release 10.1
Functional Notes
Use the realtime argument for this command to display full-screen output in real time. Information is
continuously updated on the console until you either freeze the data (by pressing the F key) or exit
realtime mode (by pressing Ctrl-C). If there is not enough room on the screen for all available data, the
information will truncate at the bottom of the screen. In order to maximize the amount of data displayed,
increase the terminal length (using the terminal length command; refer to
276 ).
61200990L1-35E
Displays a summary of all neighbors learned about through the specified interface
(e.g., eth 0/1). Type show lldp neighbors interface ? for a complete list of
applicable interfaces.
Displays a summary of all neighbors learned about through interfaces of the
specified type (e.g., eth).
Optional. Shows detailed neighbor information for the specified interface or
interface type.
Displays full-screen output in real time. See the Functional Notes below for more
information.
Command was introduced.
The real time display option was introduced.
Copyright © 2005 ADTRAN
Enable Mode Command Set
terminal length <text> on page
234