Dial-Backup Backup-Delay Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
dial-backup backup-delay <seconds>
Use the dial-backup backup-delay command to configure the amount of time the router will wait after the
failure condition is recognized before attempting to backup the link. Use the no form of this command to
return to the default value. For more detailed information on Frame Relay dial-backup functionality, refer
to the Functional Notes and Technology Review sections of dial-backup call-mode [answer |
answer-always | originate | originate-answer | originate-answer-always]
Syntax Description
<seconds>
Default Values
By default, the dial-backup backup-delay period is set to 10 seconds.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 Series units.
Command History
Release 1.1
Usage Examples
The following example configures the AOS to wait 60 seconds (on an endpoint with an active alarm
condition) before attempting dial-backup operation:
(config)#interface frame-relay 1.16
(config-fr 1.16)#dial-backup backup-delay 60
61200990L1-35E
Specifies the delay period (in seconds) a failure must be active before the AOS
will enter backup operation on the interface. Range: 10 to 86,400 seconds.
Command was introduced.
Copyright © 2005 ADTRAN
Frame Relay Sub-Interface Config Command Set
on page 725.
724