Redistribute Static (Router (Rip) Configuration Command) - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
redistribute static [metric <value>]
Use the redistribute static command to pass routes from one network to another, regardless of the routing
protocol implemented on the routing domain. Using the static keyword allows the propagation of static
routes to other interfaces using the RIP routing protocol. Use the no form of this command to disable the
propagation of the specified route type.
The gateway network for the static route must participate in RIP by using the network
command for the gateway network.
Syntax Description
metric <value>
.
Default Values
By default, RIP is not enabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 1.1
Functional Notes
Redistributing static routes allows other network devices to learn about paths (not compatible with their
system) without requiring manual input to each device on the network.
61200990L1-35E
Optional. Specifies the hop count to use for advertising redistributed OSPF routes in
RIP.
Command was introduced.
Copyright © 2005 ADTRAN
Router (RIP) Configuration Command Set
1141