Snmp-Server Community Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
snmp-server community <community> view <viewname> [ro | rw]
<listname>
Use the snmp-server community command to specify a community string to control access to the Simple
Network Management Protocol (SNMP) information. Use the no form of this command to remove a
specified community.
Syntax Description
<community>
view <viewname>
ro
rw
<listname>
Default Values
By default, there are no configured SNMP communities.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 1.1
Release 9.1
Usage Examples
The following example specifies a community named MyCommunity, specifies a previously defined view
named blockinterfaces, and assigns read-write access:
(config)#snmp-server community MyCommunity view blockinterfaces rw
61200990L1-35E
Specifies the community string (a password to grant SNMP access).
Optional. Specifies a previously defined view. Views define objects available to
the community. For information on creating a new view, see
<viewname> <oidtree> [excluded | included]
Optional. Keyword to grant read-only access, allowing retrieval of MIB objects.
Optional. Keyword to grant read-write access, allowing retrieval and modification
of MIB objects.
Optional. Specifies an access-control list name used to limit access. Refer to
access-list extended <listname>
<listname> [permit | deny] <ip address>
creating access-control lists.
Command was introduced.
view <viewname> option added.
Copyright © 2005 ADTRAN
Global Configuration Mode Command Set
on page 455
on page 344 and ip access-list standard
on page 350
for more information on
snmp-server view
.
ip
447