Soft-Reconfiguration Inbound Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide BGP Neighbor Configuration Command Set
soft-reconfiguration inbound
Use the soft-reconfiguration inbound command to enable this unit to store BGP updates for the specified
neighbor. Use the no form of this command to return to default settings.
Syntax Description
No subcommands.
Default Values
By default, this command is enabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 9.3 Command was introduced.
Functional Notes
BGP updates are stored prior to filtering, thus allowing the clear ip bgp soft command to be used in the
absence of route refresh (RFC2918) capability. This command affects all neighbors. See clear ip bgp [* |
<as-number> | <ip address>] [in | out | soft] on page 50
for more information.
Usage Examples
The following example enables the unit to store BGP updates for the specified neighbor:
(config)#router bgp-neighbor 192.22.73.101
(config-bgp-neighbor)#soft-reconfiguration inbound
61200990L1-35E Copyright © 2005 ADTRAN 1109